[darcs-users] darcs apply does not terminate.

[Thomas Zander]

Perhaps a silly suggestion;

if you do a 'darcs apply' and paste the patch in; be sure to type
control-d (twice?) to mark the end of the patch.


On Tue, Feb 01, 2005 at 10:19:59PM +0900, Yamagata Yoriyuki wrote:
> Hi,
> 
> darcs apply does not seem to terminate on my repository.  Judging from
> its size (2000 lines of code, developed for about one month), I do not
> think it is just a slowness.  Memory usage does not increase during the
> execution.  The patch comes from my coworker's repository.  Until
> today, I did development by myself, so had not used "apply" command.
> record, get commands work without problem.  Also, pushing to a empty
> repository works, too.  "darcs verify" reports the repository is
> consistent.
> 
> Unfortunately, I cannot show you a repo., since it is proprietary
> software.  Only difference from "usual cases" is that we use Japanese
> comments in patches in the repos.  (on the other hand, an applied
> patch does not contain Japanese comments) Is darcs 8-bit clean?  darcs
> version is 1.0.1  
> 
> I would appreciate any suggestion.  Tomorrow, I will try to reproduce
> the problem on a smaller example.

-- 
Thomas Zander
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: not available
Url : http://lists.osuosl.org/pipermail/darcs-users/attachments/20050201/80d1407f/attachment.pgp