[Intel-wired-lan] [PATCH S39 10/15] ice: Don't tell the OS that link is going down

[Tony Nguyen]

From: Michal Swiatkowski <michal.swiatkowski at intel.com>

Remove code that tell the OS that link is going down when user
change flow control via ethtool. When link is up it isn't certain
that link goes down after 0x0605 aq command. If link doesn't go
down, OS thinks that link is down, but physical link is up. To
reset this state user have to take interface down and up.

If link goes down after 0x0605 command, FW send information
about that and after that driver tells the OS that the link goes
down. So this code in ethtool is unnecessary.

Signed-off-by: Michal Swiatkowski <michal.swiatkowski at intel.com>
---
 drivers/net/ethernet/intel/ice/ice_ethtool.c | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/drivers/net/ethernet/intel/ice/ice_ethtool.c b/drivers/net/ethernet/intel/ice/ice_ethtool.c
index ae0b63d5673d..c302470b095b 100644
--- a/drivers/net/ethernet/intel/ice/ice_ethtool.c
+++ b/drivers/net/ethernet/intel/ice/ice_ethtool.c
@@ -2935,13 +2935,6 @@ ice_set_pauseparam(struct net_device *netdev, struct ethtool_pauseparam *pause)
 	else
 		return -EINVAL;
 
-	/* Tell the OS link is going down, the link will go back up when fw
-	 * says it is ready asynchronously
-	 */
-	ice_print_link_msg(vsi, false);
-	netif_carrier_off(netdev);
-	netif_tx_stop_all_queues(netdev);
-
 	/* Set the FC mode and only restart AN if link is up */
 	status = ice_set_fc(pi, &aq_failures, link_up);
 
-- 
2.20.1