[Intel-wired-lan] [PATCH iwl-net] idpf: extend tx watchdog timeout

Joshua Hay joshua.a.hay at intel.com
Mon Jun 3 18:47:14 UTC 2024


There are several reasons for a TX completion to take longer than usual
to be written back by HW. For example, the completion for a packet that
misses a rule will have increased latency. The side effect of these
variable latencies for any given packet is out of order completions. The
stack sends packet X and Y. If packet X takes longer because of the rule
miss in the example above, but packet Y hits, it can go on the wire
immediately. Which also means it can be completed first.  The driver
will then receive a completion for packet Y before packet X.  The driver
will stash the buffers for packet X in a hash table to allow the tx send
queue descriptors for both packet X and Y to be reused. The driver will
receive the completion for packet X sometime later and have to search
the hash table for the associated packet.

The driver cleans packets directly on the ring first, i.e. not out of
order completions since they are to some extent considered "slow(er)
path". However, certain workloads can increase the frequency of out of
order completions thus introducing even more latency into the cleaning
path. Bump up the timeout value to account for these workloads.

Fixes: 0fe45467a104 ("idpf: add create vport and netdev configuration")
Reviewed-by: Sridhar Samudrala <sridhar.samudrala at intel.com>
Signed-off-by: Joshua Hay <joshua.a.hay at intel.com>
---
 drivers/net/ethernet/intel/idpf/idpf_lib.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/intel/idpf/idpf_lib.c b/drivers/net/ethernet/intel/idpf/idpf_lib.c
index f1ee5584e8fa..3d4ae2ed9b96 100644
--- a/drivers/net/ethernet/intel/idpf/idpf_lib.c
+++ b/drivers/net/ethernet/intel/idpf/idpf_lib.c
@@ -770,8 +770,8 @@ static int idpf_cfg_netdev(struct idpf_vport *vport)
 	else
 		netdev->netdev_ops = &idpf_netdev_ops_singleq;
 
-	/* setup watchdog timeout value to be 5 second */
-	netdev->watchdog_timeo = 5 * HZ;
+	/* setup watchdog timeout value to be 30 seconds */
+	netdev->watchdog_timeo = 30 * HZ;
 
 	netdev->dev_port = idx;
 
-- 
2.39.2



More information about the Intel-wired-lan mailing list